Quick Steps For Configuring Lbd - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring Loopback Detection

Quick Steps for Configuring LBD

The following steps provide a quick tutorial on how to configure LBD. Each step describes a specific
operation and provides the CLI command syntax for performing that operation.
1
To enable the LBD protocol on a switch, use the
-> loopback-detection enable
2
To enable the LBD protocol on a port, use the
-> loopback-detection port 1/1/2 enable
Note. Once the default LBD is enabled on the switch, the remote-origin LBD can be configured. It can be
enabled globally or on a per port using the
parameter. For example:
-> loopback-detection remote-origin enable
-> loopback-detection port 1/1/2 remote-origin enable
3
Configure the LBD transmission timer by using the
command. For example:
-> loopback-detection transmission-timer 200
4
To change the auto-recovery timer for Loopback detection, use the command
autorecovery-timer. By default, the violation recovery time is 300 seconds.
-> loopback-detection autorecovery-timer 600
Note. Optional. To verify the LBD global configuration use the
verify the LBD configuration on a port use the
-> show loopback-detection
Global LBD Status
Global Remote-origin LBD Status
Global LBD Transmission Timer
Global LBD Auto-recovery Timer
-> show loopback-detection port 1/1/2
Global LBD Status
Global Remote-origin LBD Status
Global LBD Transmission Timer
Global LBD Auto-recovery Timer
Port LBD Status
Port Remote-origin LBD Status
Port LBD State
Port LBD Type
To verify the LBD statistics of a port, use the
example:
-> show loopback-detection statistics port 1/1/2
LBD Port Statistics
LBD Packet Send
Invalid LBD Packet Received
Member of Link Aggregation
See the OmniSwitch AOS Release 8 CLI Reference Guide for information about the fields in this display.
OmniSwitch AOS Release 8 Network Configuration Guide
loopback-detection
loopback-detection port
loopback-detection command with the remote-origin
loopback-detection transmission-timer
show loopback-detection
show loopback-detection port
: enabled,
: enabled,
: 200 sec,
: 600 sec,
: enabled,
: enabled,
: 200 sec,
: 600 sec,
: enabled,
: enabled,
: Inactive,
: normal-edge,
show loopback-detection statistics port
: 1
: 0
: -
December 2017
Quick Steps for Configuring LBD
command. For example:
command. For example:
loopback-detection
command or to
command. For example:
command. For
page 7-3