Clearing Erp Statistics - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring ERP
Configuring ERP Protected SVLANs
An SVLAN becomes an ERP protected SVLAN when the SVLAN is associated with two NNI ports that
also serve as ring ports. In this case, the SVLAN is automatically protected as part of the association with
NNI ring ports.
The following sequence of configuration commands provides an example of how SVLANs are
automatically added as protected SVLANs to an ERP ring:
-> ethernet-service svlan 100
-> ethernet-service svlan 200
-> ethernet-service svlan 300
-> ethernet-service svlan 400
-> ethernet-service svlan 100 nni port 1/1-2
-> ethernet-service svlan 200 nni port 1/1-2
-> ethernet-service svlan 300 nni port 1/1-2
-> erp-ring 10 port1 1/1 port 2 1/2 service-vlan 400 level 1
In the above example:
•
SVLANs 100, 200, and 300 are automatically added as protected VLANs when the ring is created.
This is due to the NNI ports being part of ERP ring 10.
•
SVLAN 400 is also automatically added as a protected VLAN when it is configured as the service
VLAN for the ring.
Use the show erp command to verify the configured VLAN Stacking ERP ring configuration. For more
information about these commands, see the OmniSwitch AOS Release 8 CLI Reference Guide.

Clearing ERP Statistics

To clear ERP statistics for all rings in the switch, use the
-> clear erp statistics
To clear ERP statistics for a specific ring in the switch, use the clear erp statistics command with the ring
parameter to specify a ring ID. For example:
-> clear erp statistics ring 5
To clear ERP statistics for a specific ring port, use the clear erp statistics command with the ring and
port parameters. For example:
-> clear erp statistics ring 5 port 1/2
To clear ERP statistics for a specific link aggregate ring port, use clear erp statistics command with the
ring and linkagg parameters. For example:
-> clear erp statistics ring 5 linkagg 2
Use the show erp statistics
see the OmniSwitch AOS Release 8 CLI Reference Guide.
OmniSwitch AOS Release 8 Network Configuration Guide
command to verify ERP statistics. For more information about this command,
clear erp statistics command. For example:
December 2017
Configuring an ERP Ring
page 11-16