Configuring The Route Preference Of A Router - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring IPv6

Configuring the Route Preference of a Router

By default, the route preference of a router is in this order: local, static, OSPFv3, RIPng, EBGP, and IBGP
(highest to lowest).
Use the ipv6 route-pref
configure the route preference of an OSPF route, you would enter:
-> ipv6 route-pref ospf 15
To display the current route preference configuration, use the
-> show ipv6 route-pref
Protocol
------------+------------------------
Local
Static
OSPF
RIP
EBGP
IBGP
OmniSwitch AOS Release 8 Network Configuration Guide
command to change the route preference value of a router. For example, to
Route Preference Value
1
2
110
120
190
200
Configuring the Route Preference of a Router
show ipv6 route-pref
December 2017
command:
page 17-19