Model Select - FUTABA 6K Instruction Manual

Model select

① Select the SELECT item and then
s e l e c t t h e m o d e l n u m b e r b y
pressing the + key or ‒ key.
＋ −
or
Selection range：1 ∼ 30
For safety, a double setting system is used. When a change is cancelled after the confirmation message is
displayed, the change is not made when moved to another setting item by Jog key.
RX type
① Select the RX item and then select
T-FHSS Air or S-FHSS by pressing
the + key or ‒ key.
＋ −
or
Selection range：T-FHSS Air,
S-FHSS
For safety, a double setting system is used. When a change is cancelled after the confirmation message is
displayed, the change is not made when moved to another setting item by Jog key.
Link
① Select the LINK item and then press the Jog key
for 1 second.
● T-FHSS Air only. S-FHSS does not enter the link
mode. Use the receiver link button to link the
receiver.
For safety, linking must not be performed while the drive motor or engine is running. When linking is
complete, turn the power off and on and check operation.
*Link is required when a new model is made from a model selection.
② P r e s s t h e Jog key f o r 1
second.
● Confirmation message
"sure?" blinks.
● Confirmation message
"sure?" blinks.
（1 second）
③ Select the model by pressing the
Jog key.
（1 second）
● A c o n f i r m a t i o n " b e e p
② RX type change by pressing the
Jog key.
● A c o n f i r m a t i o n " b e e p "
② Enters the link mode for about 20 seconds.
During this time, bring the receiver near the
transmitter and turn on the receiver power.
When linking, the receiver ID is displayed.
● In the link mode, a confirmation "beep
b e e p b e e p " s o u n d s a n d t h e t i m e
remaining is displayed on the screen.
W h e n 20 s e c o n d s h a v e e l a p s e d , a
continuous beep sounds and the link
mode is exited.
beep" sounds to show that
selection is complete.
sounds is complete.
51