Telemetry Sensor; S.bus2 Servo - FUTABA FMT-03 Instruction Manual

Telemetry sensor (sold separately)
Your aircraft's data can be checked in the transmitter by connecting various telemetry sensors to the hub
connector of the receiver.
S.BUS/S.BUS2 Servo
Use of multi-copter control box corresponding to S.BUS/S.BUS2 is presupposing for FMR-03. S.BUS/
S.BUS2 servo is connected as shown in the figure.
Terminal
●6-Terminal box (TB16PP)
Six connectors can be inserted
<Before Use>
24
Terminal
box
box
S.BUS2
Servo
Hub
S.BUS2
Servo
●4-Terminal box
Four connectors can be inserted
Futaba Telemetry Sensor
Futaba Telemetry Sensor
Futaba Telemetry Sensor
●Since the channel number is memorized by the
S.BUS servo itself, any connector can be used.
S.BUS servo channel setting device
Transmitter
with S.BUS
S.BUS2
setting
Servo
●Hub
Three connectors can be inserted.
Orange
or or CIU-2/3
SBC-1
Drivers and Link programs
＂S-Link＂ must be installed.
●Hub （Another power supply）
Used when using a separate power
supply battery.
Green