Sensor List - FUTABA 7XC Instruction Manual

This menu registers the telemetry sensors used with the transmitter. When only one of a
certain type of sensor is used, this setting is unnecessary and the sensor can be used by
simply connecting it to the S.BUS2 port of the transmitter.
When using 2 or more of the same kind of sensor, they must be registered here.
What is a slot?
Servos are classi昀椀 ed by CH, but sensors are classi昀椀 ed in units called " slots " . There are
slots from No. 1 to No. 31. Using a sensor which uses two or more slots, the required
number of slots is automatically assigned by setting up a start slot. When 2 or more of
the same kind of sensor are used, the sensors themselves must allocate unused slots and
memorize that slot.
Home screen
Slot number
About the slots that can be used.
As shown in the table below, the current sensor requires three consecutive slots, and the GPS sensor requires 8
consecutive slots. The GPS sensor (SBS - 01 / 02G) has a starting slot of 8.16.24.
The required number of
sensor
TEMP (SBS-01T)
RPM (SBS01RM)
Voltage (SBS-01V)
Current (SBS-01C)
GPS (SBS-01/02G)

Sensor List

Menu screen Telemetry menu screen
Sensor is not registered
in slot.
Slot
State with registered sensor
Change to "---------", you can make it
an empty slot.
The number which can be used as a start slot
slots
1 slot
1 slot
1 , 2 , 3 , 4 , 5 , 6 , 8 , 9 , 1 0 , 1 1 , 1 2 , 1 3 , 1 4 , 1 6 , 1 7 , 1 8 , 1 9 ,
2 slot
2 0 , 2 1 , 2 2 , 2 4 , 2 5 , 2 6 , 2 7 , 2 8 , 2 9 , 3 0
1 , 2 , 3 , 4 , 5 , 6 , 8 , 9 , 1 0 , 1 1 , 1 2 , 1 3 , 1 6 , 1 7 , 1 8 , 1 9 , 2 0 ,
2 slot
2 1 , 2 4 , 2 5 , 2 6 , 2 7 , 2 8 , 2 9
8 slot
Sensor List
Sensor list
1~31
1~31
8 , 1 6 , 2 4
161