The Port Forwarding Edit Screen - ZyXEL Communications CellPipe 7130 RG User Manual

8.3.1 The Port Forwarding Edit Screen

This screen lets you create or edit a port forwarding rule. Select User Define in
the Service Name field or click the rule's Edit icon in the Port Forwarding
screen to open the following screen.
Figure 59 Port Forwarding Edit
The following table describes the labels in this screen.
Table 44 Port Forwarding Edit
LABEL
Active
Service Name
WAN Interface
External Start
Port
External End
Port
Internal Start
Port
CellPipe 7130 RG User's Guide
DESCRIPTION
Clear the check box to disable the rule. Select the check box to enable it.
This field is not editable if you are configuring a User Define rule.
Enter a name to identify this rule. This field is read-only if you click the
Edit icon in the Port Forwarding screen.
Select a WAN interface for which you want to configure port forwarding
rules.
Enter the original destination port for the packets.
To forward only one port, enter the port number again in the External
End Port field.
To forward a series of ports, enter the start port number here and the
end port number in the External End Port field.
Enter the last port of the original destination port range.
To forward only one port, enter the port number in the External Start
Port field above and then enter it again in this field.
To forward a series of ports, enter the last port number in a series that
begins with the port number in the External Start Port field above.
Enter the port number here to which you want the CellPipe 7130 RG to
translate the incoming port. For a range of ports, enter the first number
of the range to which you want the incoming ports translated.
Chapter 8 Network Address Translation (NAT)
175