ZyXEL Communications CellPipe 7130 RG User Manual page 240

Chapter 18 Remote Management
7130 RG. You have to enable the device to be managed by the ACS and specify
the ACS IP address or domain name and username and password.
Click Advanced > Remote MGMT to open the following screen. Use this screen
to configure your CellPipe 7130 RG to be managed by an ACS.
Figure 96 TR-069
The following table describes the fields in this screen.
Table 78 TR-069
LABEL
Inform
Inform Interval
ACS URL
ACS User Name
ACS Password
WAN Interface
used by TR-069
client
Display SOAP
messages on
serial console
Connection
Request
Authentication
240
DESCRIPTION
Select Enable to activate remote management via TR-069 on the
WAN. Otherwise, select Disable.
Enter the time interval (in seconds) at which the CellPipe 7130 RG
sends information to the auto-configuration server.
Enter the URL or IP address of the auto-configuration server.
Enter the TR-069 user name for authentication with the auto-
configuration server.
Enter the TR-069 password for authentication with the auto-
configuration server.
Select a WAN interface through which the TR-069 traffic passes.
If you select Multi_WAN, you should also select the pre-configured
WAN connection(s).
Select Enable to show the SOAP messages on the console.
Select this option to enable authentication when there is a connection
request from the ACS.
CellPipe 7130 RG User's Guide