ZyXEL Communications CellPipe 7130 RG User Manual page 294

Chapter 26 Troubleshooting
I cannot create multiple connections of the same type.
Your layer-2 interface must be in VLAN MUX Mode or MSC mode to create multiple
WAN serivces for each connection.
I cannot access the Internet anymore. I had access to the Internet (with the
CellPipe 7130 RG), but my Internet connection is not available anymore.
Check the hardware connections, and make sure the LEDs are behaving as
1
expected. See the Quick Start Guide and
Turn the CellPipe 7130 RG off and on.
2
If the problem continues, contact your ISP.
3
The Internet connection is slow or intermittent.
There might be a lot of traffic on the network. Look at the LEDs, and check
1
1.6 on page
information, try closing some programs that use the Internet, especially peer-to-
peer applications.
Check the signal strength. If the signal strength is low, try moving your computer
2
closer to the CellPipe 7130 RG if possible, and look around to see if there are any
devices that might be interfering with the wireless network (for example,
microwaves, other wireless networks, and so on).
Turn the CellPipe 7130 RG off and on.
3
If the problem continues, contact the network administrator or vendor, or try one
4
of the advanced suggestions.
Advanced Suggestions
• Check the settings for QoS. If it is disabled, you might consider activating it. If it
is enabled, you might consider raising or lowering the priority for some
applications.
294
26. If the CellPipe 7130 RG is sending or receiving a lot of
Section 1.6 on page 26.
CellPipe 7130 RG User's Guide
Section