ZyXEL Communications CellPipe 7130 RG User Manual page 291

I cannot see or access the Login screen (or other screens) in the web
configurator.
Make sure you are using the correct IP address.
1
• The default IP address is http://192.168.1.1.
• If you changed the IP address
address.
• If you changed the IP address and have forgotten it, see the troubleshooting
suggestions for
Check the hardware connections, and make sure the LEDs are behaving as
2
expected. See the Quick Start Guide.
Make sure your Internet browser does not block pop-up windows and has
3
JavaScripts and Java enabled. See
Reset the device to its factory defaults, and try to access the CellPipe 7130 RG
4
with the default IP address. See
If the problem continues, contact the network administrator or vendor, or try one
5
of the advanced suggestions.
Advanced Suggestions
• If your computer is connected to the WAN port or is connected wirelessly, use a
computer that is connected to an ETHERNET port.
• Try to access the CellPipe 7130 RG using another service, such as Telnet. If you
can access the CellPipe 7130 RG, check the remote management settings and
firewall rules to find out why the CellPipe 7130 RG does not respond to HTTPS.
I can see the Login screen, but I cannot log in to the CellPipe 7130 RG.
Make sure you have entered the user name and password correctly. The default
1
admin user name is admin and default admin password is telus. These fields are
case-sensitive, so make sure [Caps Lock] is not on.
Note: Refer to
its own account information for logging into the CellPipe 7130 RG.
Turn the CellPipe 7130 RG off and on.
2
CellPipe 7130 RG User's Guide
(Section on page
I forgot the IP address for the CellPipe 7130 RG.
Appendix C on page
Section 1.7 on page
Section 3.2 on page 83
Chapter 26 Troubleshooting
135), use the new IP
351.
28.
for user level information. Each user level has
291