Table of Contents
Advertisement
Chapter 16 Quality of Service (QoS)
The following table describes the labels in this screen.
Table 68 QoS General
LABEL
Active QoS
WAN Managed
Upstream
Bandwidth
Apply
Cancel
16.4 The Queue Setup Screen
Click QoS > Queue Setup to open the screen as shown next.
Use this screen to configure QoS queue assignment.
Figure 88 QoS Queue Setup
222
DESCRIPTION
Select the check box to turn on QoS to improve your network
performance.
Enter the amount of upstream bandwidth for the WAN interface that you
want to allocate using QoS.
The recommendation is to set this speed to match the interface's actual
transmission speed. For example, set the WAN interface speed to
100000 kbps if your Internet connection has an upstream transmission
speed of 100 Mbps.
You can set this number higher than the interface's actual transmission
speed. The CellPipe 7130 RG uses up to 95% of the DSL port's actual
upstream transmission speed even if you set this number higher than
the DSL port's actual transmission speed.
You can also set this number lower than the interface's actual
transmission speed. This will cause the CellPipe 7130 RG to not use
some of the interface's available bandwidth.
If you leave this field blank, the CellPipe 7130 RG automatically sets this
number to be 95% of the DSL port's actual upstream transmission
speed.
Click Apply to save your changes back to the CellPipe 7130 RG.
Click Cancel to begin configuring this screen afresh.
CellPipe 7130 RG User's Guide
Advertisement
Table of Contents
Troubleshooting
