Table of Contents
Advertisement
16.6 The Policer Setup Screen
Click QoS > Policer Setup to open the following screen. The CellPipe 7130 RG
can control ingress (or incoming) traffic by dropping packets that exceed the
committed rate and/or committed burst size specified in this screen.
A policer is a QoS policy.
Figure 92 Policer Setup
The following table describes the labels in this screen.
Table 73 Policer Setup
LABEL
Add
No
Active
Name
Regulated
Classes
Meter Type
Committed Rate
Committed Burst
Size
Modify
Apply
CellPipe 7130 RG User's Guide
DESCRIPTION
Click this button to create a new policy.
This field displays the index number of the policy.
Select the check box to enable the policy.
This is the name of the policy.
This shows to which classes the policy applies.
This is set to Simple Token Bucket, which is similar to tokens in a
bucket to control when traffic can be transmitted. The bucket is a
buffer that temporarily stores outgoing packets and transmits them at
an average rate.
This shows the maximum committed rate for the specified class/es.
This shows the maximum committed burst size for the specified class/
es.
Click the Edit icon to go to the screen where you can edit the
classifier.
Click the Remove icon to delete an existing classifier. Note that
subsequent rules move up by one when you take this action.
Click Apply to save your changes back to the CellPipe 7130 RG.
Chapter 16 Quality of Service (QoS)
231
Advertisement
Table of Contents
Troubleshooting
