The Firewall Screen - ZyXEL Communications CellPipe 7130 RG User Manual

11.3 The Firewall Screen

Click Security > Firewall > Incoming to display the following screen. This
screen displays a list of the configured incoming filtering rules.
Figure 69 Firewall > Incoming
The following table describes the labels in this screen.
Table 52 Firewall > Incoming
LABEL
Active Firewall
Active
Filter Name
Interfaces
Protocol
Source Address
/ Mask
Source Port
Dest. Address /
Mask
Dest. Port
Start. Time
Stop. Time
Week. Days
Modify
CellPipe 7130 RG User's Guide
DESCRIPTION
Select this check box to enable the firewall on the CellPipe 7130 RG.
When the firewall is enabled, the CellPipe 7130 RG blocks all incoming
traffic from the WAN to the LAN. Create custome rules below to allow
certain WAN users to access your LAN or to allow traffic from the WAN
to a certain computer on the LAN.
Select this check box to enable the rule.
This displays the name of the rule.
This displays the WAN interface(s) to which this rule is applied.
This displays the transport layer protocol that defines the service to
which this rule applies.
This displays the source IP addresses and subnet mask to which this
rule applies. Please note that a blank source address is equivalent to
Any.
This is the source port number.
This displays the destination IP addresses and subnet mask to which
this rule applies. Please note that a blank destination address is
equivalent to Any.
This is the destination port number.
This displays the time at which the firewall schedule begins.
This displays the time at which the firewall schedule ends.
This displays the day(s) of the week the firewall schedule is effective.
Click the Edit icon to go to the screen where you can edit the rule.
Click the Remove icon to delete an existing rule. Note that subsequent
rules move up by one when you take this action.
Chapter 11 Firewall
193