ZyXEL Communications CellPipe 7130 RG User Manual page 111

Note: When a Connect interface is in VLAN MUX Mode or MSC Mode, you can
configure up to eight WAN services shared by both interfaces.
Figure 22 Network > WAN > Services
The following table describes the labels in this screen.
Table 18 Network > WAN > Services
LABEL
Interface
Description
Type
CellPipe 7130 RG User's Guide
DESCRIPTION
This shows the name of the interface used by this connection.
A default name atmx or ptm0_x (where x starts from 0 and is the
index number of ATM layer-2 interface) indicates the DSL port.
The ppp0_x name (where x starts from 1 and is the index number of
PPP connection on the CellPipe 7130 RG) indicates a PPP connection
via any one of the WAN interface.
The eth4_x (where x starts from 1 and is the index number of
ethernet connection on the CellPipe 7130 RG) indicates the Ethernet
WAN interface (the physical Ethernet WAN port).
The number after the underscore (_) represents either the index
number of connections through the same interface or the VPI/VCI
values assigned to the ATM layer-2 interface.
The number after the dot (.) represents the VLAN ID number assigned
to traffic sent through this connection.
(null) means the entry is not valid.
This is the service name of this connection.
The first number represents the index number of connections over the
same PVC or the VLAN ID number assigned to traffic sent through this
connection. The next two numbers are the VPI and VCI numbers. 0
and 33 are the default VPI and VCI numbers.
(null) means the entry is not valid.
This shows the layer-2 interface type and method of encapsulation
used by this connection.
IPoW stands for IPoE used in an Ethernet WAN connection.
Chapter 5 WAN Setup
111