Cellpipe 7130 Rg Access And Login - ZyXEL Communications CellPipe 7130 RG User Manual

Chapter 26 Troubleshooting
Make sure you understand the normal behavior of the LED. See
1
page 26.
Check the hardware connections. See the Quick Start Guide.
2
Inspect your cables for damage. Contact the vendor to replace any damaged
3
cables.
Turn the CellPipe 7130 RG off and on.
4
If the problem continues, contact the vendor.
5

26.2 CellPipe 7130 RG Access and Login

Note: Refer to
its own account information for logging into the CellPipe 7130 RG.
I forgot the IP address for the CellPipe 7130 RG.
The default IP address is http://192.168.1.1.
1
If you changed the IP address and have forgotten it, you might get the IP address
2
of the CellPipe 7130 RG by looking up the IP address of the default gateway for
your computer. To do this in most Windows computers, click Start > Run, enter
cmd, and then enter ipconfig. The IP address of the Default Gateway might be
the IP address of the CellPipe 7130 RG (it depends on the network), so enter this
IP address in your Internet browser.
If this does not work, you have to reset the device to its factory defaults. See
3
Section 1.7 on page
I forgot the password.
The default admin password is telus and the default user password is admin.
1
Note: Refer to
its own account information for logging into the CellPipe 7130 RG.
If this does not work, you have to reset the device to its factory defaults. See
2
Section 1.7 on page
290
Section 3.2 on page 83
28.
Section 3.2 on page 83
28.
for user level information. Each user level has
for user level information. Each user level has
CellPipe 7130 RG User's Guide
Section 1.6 on