Spanning-Tree Forward-Time; Spanning-Tree Hello-Time - Planet WGSD-1022 User Manual

User Guidelines
There are no user guidelines for this command.
Example
The following example configures the spanning-tree protocol to RSTP.
Console(config)# spanning-tree mode rstp

5.21.3 spanning-tree forward-time

The spanning-tree forward-time global configuration command configures the spanning-tree bridge forward time, which is the
amount of time a port remains in the listening and learning states before entering the forwarding state.
To reset the default forward time, use the no form of this command.
Syntax
spanning-tree forward-time seconds
no spanning-tree forward-time
seconds — Time in seconds .(Range: 4 - 30)
Default Configuration
The default forwarding-time for IEEE Spanning-tree Protocol (STP) is 15 seconds.
Command Modes
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures spanning-tree bridge forward time to 25 seconds.
Console(config)# spanning-tree forward-time 25

5.21.4 spanning-tree hello-time

The spanning-tree hello-time global configuration command configures the spanning-tree bridge hello time, which is how often
the switch broadcasts hello messages to other switches.To reset the default hello time, use the no form of this command.
User's Manual of WGSD-1022/WGSD-8000
- 296 –