Spanning-Tree Commands; Spanning-Tree; Spanning-Tree Mode - Planet WGSD-1022 User Manual

5.21 Spanning-Tree Commands

5.21.1 spanning-tree

The spanning-tree global configuration command enables spanning-tree functionality. To disable spanning-tree functionality,
use the no form of this command.
Syntax
spanning-tree
no spanning-tree
Default Configuration
Spanning-tree is enabled.
Command Modes
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables spanning-tree functionality.
Console(config)# spanning-tree

5.21.2 spanning-tree mode

The spanning-tree mode global configuration command configures the spanning-tree protocol. To return to the default
configuration, use the no form of this command.
Syntax
spanning-tree mode {stp | rstp}
no spanning-tree mode
stp — STP is supported.
rstp — RSTP is supported.
Default Configuration
Spanning-tree protocol (STP) is supported.
Command Modes
Global Configuration mode
User's Manual of WGSD-1022/WGSD-8000
- 295 –