The page contains the following fields:
Via TFTP
• Via TFTP Upgrade
• TFTP Server
• Source File
• Destination File
Via HTTP
This HTTP Firmware Upgrade screen is used for saving configuration information using your Web browser. See figure 4-75
• Upgrade
Figure 4-74 Save Configuration via TFTP
Select this option to upgrade the switch from a file located on a TFTP
Server.
The TFTP Server IP Address that contains the source file to upgrade
from.
Specifies the name of the upgrade file on the TFTP Server.
Where specifies the name of the configuration file. The default is
StartupCfg.
Figure 4-75 Save Configuration via HTTP
Select this option to upgrade the switch from a file on the local hard
drive.
- 145 –
User's Manual of WGSD-1022/WGSD-8000