Show Ip Interface - Planet WGSD-1022 User Manual

Default Configuration
No default gateway is defined.
Command Mode
Interface configuration
User Guidelines
The setting of the default gateway on the out-of-band port must not precede the assignment of the IP address.
Always assign the IP address to the out-of-band port first, and then set the default gateway.
Example
The following example defines an ip default gateway.
Console(config)# ip default-gateway 192.168.1.1

5.10.4 show ip interface

The show ip interface user EXEC command displays the usability status of interfaces configured for IP.
Syntax
show ip interface [ethernet interface-number | vlan vlan-id | port-channel number]]
ethernet interface-number — Ethernet port number.
vlan vlan-id — VLAN number.
port-channel number — Port-channel number.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays VLAN 1 configuration.
Console# show ip interface vlan 1
User's Manual of WGSD-1022/WGSD-8000
- 233 –