• Subnet Mask
• Deafault Gateway
• DNS Server
4.2.3 Time
In the Basic Setup Table, you can see the Time Setup (see figure 4-5), by which you can configure the time settings for the
Switch.
You can select SNTP Servers: Server1 for the primary SNTP server and Server2 for the secondary SNTP server.
The Time page includes the following fields:
Set Time
• Use System Time
• Use SNTP Time
Local Time
Enter the IP subnet mask for the interface.
The factory default value is 255.255.255.0
Enter the default gateway for the IP interface.
The factory default value is 0.0.0.0
Enter the IP Address of the DNS Server. The Domain Name System (DNS)
converts user-defined domain names into IP addresses.
Figure 4-5 Time screen
Specifies that the system time is not set by an external source but the Local time
settings.
Specifies that the system time is set via an SNTP server
User's Manual of WGSD-1022/WGSD-8000
- 34 –