Planet WGSD-1022 User Manual page 250

Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
To test optical transceivers ensure a fiber link is present.
Examples
The following example displays the optical transceiver diagnostics.
console# show fiber-ports optical-transceiver
Port Temp
------ --------
g1 W
g2 OK
e3 Copper
Temp – Internally measured transceiver temperature.
Voltage - Internally measured supply voltage.
Current – Measured TX bias current.
Output Power – Measured TX output power.
Input Power – Measured RX received power.
Tx Fault – Transmitter fault
LOS – Loss of signal
Data ready – Indicates transceiver has achieved power up and data is ready.
N/A - Not Available, N/S - Not Supported, W - Warning, E - Error
The following example displays detailed optical transceiver diagnostics
console# show fiber-ports transceiver detailed
Port Temp
[C]
Voltage Current
Power
------------ ------------
OK E
OK OK
Voltage Current
[Volt] [mA]
User's Manual of WGSD-1022/WGSD-8000
Output Input
Power Power
----------- ----------
OK OK
OK OK
Output Input
Power Power
[mWatt] [mWatt]
- 250 –
LOS
---------
OK
OK
LOS