Planet WGSD-1022 User Manual page 37

The Port Settings screen contains the following fields:
• Port
• Description
• Admin Status
• Link Status
• Speed
• Duplex
• MDI/ MDIX
• Flow control
Figure 4-6 Port Settings screen
Shows the port number. You can click on the Detail button of the appropriate port
(G1, G2) to use an SFP module, and the Detail button shows the Port Configuration
Detail screen, which include port, description, port type, admin status, current port
status ......
Click up the Detail button to make a brief description of the port
When to choose the UP button, the port can be accessed normally, to choose the
Down button, the port will be taken offline
Shows an active connection when you choose the UP button, there is no active
connection or the port has been taken offline by an Admiinistrator when you choose
the Down button
Shows the connection speed of the port and the speed can be configured only
when auto-negotiation is disabled on that port
The port duplex mode, Full (transmission occurs in both directions simultaneously)
or Half (transmission occurs in only one direction at a time). This mode can be
configured only when auto-negotiation is disabled and port speed is set to 10Mbps
or 100Mbps.
It cannot be configured on Link Aggregation Groups (LAGs)
Shows the MDI/MDIX status of the port. To use the MDI setting if the port is
connected to an end station. To use the MDIX setting if the port is connected to a
hub or another switch
Shows the flow control status of the port. It is active when the port uses Full Duplex
User's Manual of WGSD-1022/WGSD-8000
- 37 –