Queue Setting - Planet WGSD-1022 User Manual

The Page contains the following fields:
• CoS Mode
• Class of Service
• Queue
The Restore Defaults button restores the device factory defaults for mapping CoS values to a forwarding queue.
CoS Default:
The Table contains the following fields:
• Interface
• Default CoS
• Restore Defaults
• LAG

4.8.2 Queue Setting

The Queue Setting screen (see figure 4-36) contains fields for defining the QoS queue forwarding types.
Figure 4-35 CoS Settings screen
This indicates if QoS is enabled on the interface. The possible values are:
• Disable, disables QoS on the interface.
• Basic, enables QoS on the interface.
• Advanced, enables the Advanced Mode QoS on the interface.
Specifies the CoS priority tag values, where zero is the lowest and 7 is the highest
Defines the traffic forwarding queue to which the CoS priority is mapped.
Four traffic priority queues are supported
Interface to which the CoS configuration applies
Determines the default CoS value for incoming packets for which a VLAN tag is not
defined. The possible field values are 0-7.
The default CoS is 0
Restores the device factory defaults for mapping CoS values to a forwarding
queue.
LAG to which the CoS configuration applies.
User's Manual of WGSD-1022/WGSD-8000
- 90 –