Avaya 1120E User Manual page 43

2. Use the stand cover to mark the wall-mount holes by pressing the bottom of the stand cover
firmly against the wall in the location where you wish to install the IP Deskphone. Four small
pins on the bottom of the stand cover make marks on the wall.
3. Use the marks as a guideline for installing the wall-mount screws (not provided). Install the
screws so that they protrude 3 millimeters (mm) (1/8 inch) from the wall.
4. Install the IP Deskphone stand mounting holes over the screw heads as indicated in the
following figure — Method A. You need to remove the IP Deskphone from the wall to adjust
the lower screws.
5. When the lower screws are snug, install the IP Deskphone on the mounting screws, and
then tighten the top screws.
Figure 10: Cable routing tracks and mounting holes
Method B:
1. Attach the 15-cm (6-inch) CAT5e cable.
2. Position the stand over the mounting rivets, and slide the IP Deskphone down the wall so
that the rivets fit into the slots on the stand, indicated in the preceding figure — Method B.
3. Replace the stand cover. Ensure that all cables are neatly routed and press the stand cover
into place until you hear a click.
4. Put the IP Deskphone in the wall-mount position (optional). If you wall-mount your IP
Deskphone, put it in the wall-mount position by holding the Tilt Lever and pressing the IP
May 2016 Avaya 1120E IP Deskphone with SIP Software on Avaya Aura
Comments on this document? infodev@avaya.com
Connecting the components
®
User Guide 43