Nfx150-S1 Front Panel And Rear Panel; Mount An Nfx150-S1 Device On Two Posts Of A Rack - Juniper NFX150-S1 Quick Start Manual

NFX150-S1 Network Services Platform Quick Start

NFX150-S1 Front Panel and Rear Panel

Figure 1: Front Panel Components of NFX150-S1
1 2 3
9 8
1— Mini USB console Port
2— RJ-45 console port
3— One 10/100/1000BASE-T RJ-45 management port
4— Four 10/100/1000BASE-T RJ-45 LAN ports
5—System status LEDs
Figure 2: Rear Panel Components of NFX150-S1
1 2
7
1— AC power cord inlet
2— Power switch
3— Grounding point
4—Serial number

Mount an NFX150-S1 Device on Two Posts of a Rack

To mount an NFX150-S1 device on a rack, you require the parts that are shipped with the device along with the following additional
parts and equipment. These are not shipped with the device.
Electrostatic discharge (ESD) grounding strap
Four screws to secure the chassis and mounting bracket to the rack
Phillips (+) screwdriver, number 2
Management host, such as a PC or laptop, with a serial port
Grounding cable (minimum 14 AWG (2 mm²), minimum 90°C wire), grounding lug (Panduit LCC10-14BWL or equivalent), a
pair of 10-32x.25-in. screws, and a pair of flat washers
2
4
7
3
5
6— Expansion module slots
7— Two 1-Gigabit Ethernet/10-Gigabit Ethernet SFP+ WAN ports
8— USB 3.0 port
9— Reset button
4
6
5— Fans
6— CLEI code
7— Electrostatic discharge (ESD) point
6
5
Copyright © 2018, Juniper Networks, Inc.