Installing A Jrr200 Route Reflector Dc Power Supply; Figure 18: Removing A Dc Power Supply - Juniper JRR200 Hardware Manual

Copyright © 2018, Juniper Networks, Inc.
Unscrew the locking screws counterclockwise by using the screwdriver.
5.
Remove the cable lugs from the input DC terminals.
6.
Slide the ejector lever toward the left until the power supply is unseated.
7.
Grasp the power supply handle and pull firmly to slide the power supply halfway out
8.
of the chassis.
Taking care not to touch power supply pins, leads, or solder connections, place one
9.
hand under the power supply to support it. Grasp the power supply handle with your
other hand and pull the power supply completely out of the chassis.

Figure 18: Removing a DC Power Supply

Place the power supply in the antistatic bag or on the antistatic mat placed on a flat,
10.
stable surface.

Installing a JRR200 Route Reflector DC Power Supply

Ensure that you have the following parts and tools available:
ESD grounding strap
CAUTION: Do not mix AC and DC power supplies in the same chassis.
To install a DC power supply (see
Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD
1.
point on the chassis.
Taking care not to touch power supply pins, leads, or solder connections, remove the
2.
power supply from the bag.
Chapter 4: Maintaining Components
Figure 19 on page 60):
59