Deleting Paths From Faders; Lock A Fader To The Surface - Calrec SUMMA User Manual

Alternatively, once your chosen faders are selected, touch and hold again to make your selection float over the fader
layout screen. From here drag your selection across the screen to your desired location. As you tap or drag across
possible destinations, previews of new path placements appear to help with your decision. The colour indication system
described above is used.
Once you have selected your destination you are presented with three options: CANCEL; SWAP—swaps the original
paths with those on the chosen destination faders; OVERWRITE —replaces the destination path with your original
selection and removes the destination paths from the surface. As channels don't exist once they are removed from a
fader a pop-up appears if you attempt to overwrite a channel requiring you to confirm your choice.

Deleting Paths from Faders

To remove a path from a fader:
1. Select one or more faders, at least one of which must have a path attached.
2. Tap DELETE in the window footer.
As channel paths don't exist once they are removed from faders, if you attempt to delete a channel, a pop-up appears
showing the paths that you are attempting to delete, requiring you to confirm your selection.

Lock a Fader to the Surface

Layer lock allows you to ensure some faders are always present on the surface, regardless of which layer is selected.
1. Select one or more faders (with or without paths attached).
2. Tap LOCK in the window footer.
The selected faders are then locked to the surface and will remain there regardless of layer selection.
80 SUMMA
Networked Audio Production System
GETTING SIGNALS IN AND OUT