Moving A Gpi Destination; Removing A Destination; User Buttons - Calrec SUMMA User Manual

Moving a GPI destination

1. Tap a destination and tap MOVE in the window footer.
2. Select a new destination and tap MOVE again, or tap CANCEL to discard any changes.

Removing a Destination

1. Tap one or more destinations and tap REMOVE in the window footer.
2. Tap REMOVE again to confirm or tap CANCEL to discard any changes.
FIGURE 1 - GPI

User Buttons

The 12 User Buttons in Summa's eight-fader section each have white LED indicators. They can be assigned to directly
control a range of functions previously only available through the touch screen UI.
FIGURE 2 - USER BUTTONS
These buttons can be set up to change monitor
sources, change monitor settings talk to internal buses,
start and stop loudness meters, bypass AutoMixers
and interact with the On-Air protection system. User
buttons controlling any of these functions can also be
connected to GPOs to simultaneously trigger external
equipment. For example a user button that is set up to
switch a monitor source, could also connect to a GPO
to trigger a vision switcher to switch to an appropriate
video feed. The indicators within the User buttons can be
used as Tallies to indicate that a corresponding GPI has
been activated. This can also be used as a method for
checking the correct operation of a GPIO circuit.
CALREC
Putting Sound in the Picture
173