REMOTE CONTROL – CSCP
In addition to GPI activated controls, the Hydra2 product range supports several protocols to allow 3rd party
equipment to remotely control various features. CSCP (Calrec Serial Control Protocol) can be used to remotely
automate various Summa features.
CSCP
Calrec Serial Control Protocol (CSCP) allows remote control, using third party equipment, of the following:
•
Fader positions (including VCA master faders)
•
Path cut/on status
•
PFL status
•
Routing to auxs and mains
•
Aux output levels
•
Main output Level
•
'Left to both' and 'right to both' switching
CSCP can be enabled and disabled per fader:
1. Press a fader's ACCESS button.
2. Tap the fader processing tab.
3. Tap CSCP ENABLE in the window header to switch on or off.
When a fader is under CSCP control, this can be overridden by touching and dragging the fader to the desired level.
Setting Up CSCP
Tap SYSTEM SETTINGS in the top right of the screen and select CONTROL PROTOCOLS from the left hand menu.
In this window you can configure each CSCP controller device that you wish to connect to your network. On the left
of the screen the LAN port IP address information is displayed (see
information) so that you have it available for configuring your CSCP controller. On the right of the screen you can add
your CSCP interface, EDIT the settings, switch on the connection or DELETE the controller from the system. By default,
the Assist CSCP interface will already be defined. Use CSCP version 21 unless you have been advised otherwise by a
Calrec engineer.
176 SUMMA
Networked Audio Production System
"Configuring LAN Ports" on page 176
for more
EXTERNAL INTERFACING