Calrec SUMMA User Manual page 69

General Settings:
• By default, a notch can be felt at the '0' point on the fader scale. This can be switched off if required.
• The surface layer buttons can be set to operate in one of two ways. They either change all linked fader sections or
only the sections which contains the accessed fader, plus any sections which are linked to that section.
• By default, PFL can be activated momentarily by pulling the fader down below its lowest point, and deactivated once
released. This feature can be switched off for the whole surface.
• By default, if a fader is closed and it's PFL is activated, it will be automatically deactivated once the fader is opened.
This feature can be switched off for the whole surface. (see
• VCA groups are generally made and dissolved by pressing fader access buttons but this process can be disabled to
protect all VCA assignments or to stop VCA groups being made accidentally.
• By default, VCA slave faders move automatically when their levels are changed by their masters. If you would rather,
this functionality can be switched off and instead slaves will remain stationary. Combined master/slave levels will still
be indicated by the nulling indicators in the fader displays. (see
Other settings are explained in the relevant sections:
"External Inputs" on page 93
FIGURE 4 - SHOW SETTINGS
CALREC
Putting Sound in the Picture
"PFL, AFL and Output Listen" on page
"VCA Groups" on page
"Delay" on page 138 , "Downmixing" on page 167
111).
142)
and
69