Oscillator Controls
Internal tone signals are generated by Summa's oscillator which can be controlled from the oscillator setup area.
To access this, tap OSCILLATOR in the Show menu.
Summa has one internal oscillator which is controlled using the two rotary controls towards the bottom of the window:
level and frequency. You can set the oscillator to generate a fixed tone at the specified frequency, or a stepped 20 Hz
to 20 kHz tone sweep.
Different tone sources can be set for each path width (mono, stereo and 5.1) using the internal and external tone
source buttons. Selecting INTERNAL uses Summa's internal oscillator as the tone source for that path width, whereas
selecting EXTERNAL uses the feed that is currently patched to Summa's external tone input. Each leg of a stereo or
5.1 tone source can be muted individually.
FIGURE 5 - OSCILLATOR CONTROLS
Clearing Tone
Tap CLEAR TONE at the bottom of the OSCILLATOR window to quickly switch off all tone on all paths.
Tone and Talkback Active Notification
Notifications appear in the main header when any tone or talkback is active.
The notifications can be tapped to clear all tone or talkback. See Figure 6 below.
FIGURE 6 - TONE AND TALKBACK ACTIVE NOTIFICATIONS
CALREC
Putting Sound in the Picture
103