Installation; Service Personnel; Third Party Equipment; Esd (Static) Handling Procedures - Calrec SUMMA User Manual

Installation

In many installations the AC power connectors will not be readily accessible, effectively making the equipment
permanently connected. The installation should be carried out in accordance with all applicable installation rules and
regulations.

Service Personnel

The AC power disconnect devices are the 2 x IEC (IEC60320-1 C13/C14) couplers located at the rear of each unit.
WARNING: The apparatus has a dual power system. It is essential that BOTH AC power IEC couplers are disconnected
to prevent exposure to hazardous voltage within the unit.

Third Party Equipment

Integrating third party equipment into a Calrec system may compromise the product's ability to comply with the Class B
radiated emission limits set in the EMC (Electro Magnetic Compatibility) standard EN55022.
Calrec Audio Limited can not be responsible for any non-conformities due to use of third party equipment. If in doubt,
please contact Calrec Audio Limited for guidance prior to integrating any third party equipment.

ESD (Static) Handling Procedures

In its completed form, this equipment has been designed to have a high level of immunity to static discharges. However,
when handling individual boards and modules, many highly static-sensitive parts are exposed. In order to protect these
devices from damage and to protect your warranty, please observe static handling procedures, for example, use an
appropriately grounded anti-static wrist band. Calrec will supply an electrostatic cord and wrist strap with all of its digital
products.
All modules and cards should be returned to Calrec Audio Limited in anti-static wrapping. Calrec Audio Limited can
supply these items upon request, should you require assistance. This applies particularly to digital products due to the
types of devices and very small geometries used in their fabrication, analogue parts can however still be affected.

RoHS Legislation

In order to comply with European RoHS (Reduction of Hazardous Substances) legislation, Calrec PCB and cable
assemblies are produced with lead-free (tin/copper/silver) solder instead of tin/lead solder.
In the unlikely event of a customer having to carry out any re-soldering on Apollo, Artemis or Hydra2 hardware, it is
imperative that lead-free solder is used; contaminating lead-free solder with leaded solder is likely to have an adverse
effect on the long-term reliability of the product. Circuit boards assembled with lead-free solder can be identified
(in accordance with IPC/JEDEC standards) by a small oval logo on the top-side of the circuit board near the PCB
reference number (8xx-xxx). The same logo is used on the connector hoods of soldered cable assemblies.
If in doubt, please check with a Calrec customer support engineer before carrying out any form of re-soldering.

ISO 9001 and RAB Registered

Calrec Audio Ltd has been issued the ISO9001: 2008 standard by the Governing Board of ISOQAR.
The award, for both UKAS and RAB registration, is the most comprehensive of the ISO9000 international standards.
Granted in recognition of excellence across design, development, manufacture and after- sales support, the certification
follows a rigorous and thorough review of Calrec's internal and external communication and business procedures.
16 SUMMA
Networked Audio Production System
PRODUCT INFORMATION