Layers; Layer Switching Options - Calrec SUMMA User Manual

LAYERS

The Summa surface has six layers allowing fader-control of 6 times as many paths as there are faders on the
surface. You can switch between layers using the layer selection buttons 1– 6 on the surface. Layer switching
options can be set per fader section. Fader sections can be 'linked', so that if a section's layer is changed, the layer
will also change for all linked sections.
Layer linking options are set from the Surface Layer pop-up which is accessible from the Monitor bar along the bottom of
the Touch Display. This should be used along with Layer Switching Options which are located within Show settings.
When changing layer, all fader positions, button states and control cell states (if in a strip mode) change immediately to
reflect faders on the newly selected layer.

Layer Switching Options

To access layer switching options, tap SHOW SETTINGS in the Show menu and select 'General'. One of these two
options can be chosen:
• Change the layer of all linked fader sections
• Change only the layer of the fader section containing the Accessed fader (any linked fader sections will also
change too)
The first option can be used if you wish to prevent a section of the desk from ever switching layers. For example, on a
Summa 36+8, linking sections 1, 2 and 4 and selecting the first layer switching option means that all surface sections,
other than section 3, will switch layers when surface layer buttons or pop-up layer buttons are pressed. Fader section 3
will stay on which ever layer you select for it within the Surface Layer pop-up.
The second layer switching option should be chosen if you always want the section containing the currently accessed
fader to switch layers (along with any linked surface sections) regardless of whether you have set some fader sections to
lock to a specific layer.
FIGURE 1 - LAYER SETTINGS
50 SUMMA
Networked Audio Production System
SYSTEM OVERVIEW