Duplicating A Show; Deleting A Show; Editing A Show; Moving Shows Between Summa Systems With 180 And 128 Channels - Calrec SUMMA User Manual

Duplicating a Show

Duplicating Shows can save time when several very similar Shows are needed:
1. Select a Show and tap DUPLICATE in control window footer.
2. Enter a new label.
3. Tap DUPLICATE or CANCEL.

Deleting a Show

1. Tap to select one or more Shows within the list.
2. Tap DELETE in the control window footer.
3. Tap DELETE SELECTED, or CANCEL.

Editing a Show

Once a Show has been created it is possible to edit its label and description:
1. Select the Show that you wish to edit and tap EDIT in the control window footer.
2. Make changes to the label and description in the pop-up.
3. Tap SAVE or CANCEL .

Moving Shows between Summa Systems with 180 and 128 channels

When moving a show from a 180 channel Summa to a 128 channel Summa, it is possible that some channels cannot be
created due to the smaller DSP capacity. The user is notified about which channels were not created, allowing them to
understand how the mix will be affected.
Summa also supports moving shows between systems with different surface sizes. If the user loads a show made on a
large surface, onto a surface with fewer faders, they will have access to virtual fader sections, allowing the user to move
the inaccessible paths onto faders and layers that they can access on the smaller surface.
Show Templates—Admin Only
Whenever you create a new Show it must be based on a template. The generic Calrec template is always available.
Additional templates can be created by Summa administrators. Show templates hold the same data as Shows but they
cannot be opened, edited or deleted without logging in as an administrator.
Setting Up and Editing Templates—Admin Only
Enter the shows list screen and tap SHOW TEMPLATES to the left of the window header. You are required to enter
the admin username and password for the system you are using, then tap LOG IN and you have access to the available
Show templates.
From here you can create a new template by tapping NEW and entering client, series and label information. You
can delete a template (other than the Calrec default template) by selecting it and tapping DELETE . You can edit a
template's details by selecting it and tapping EDIT .
Updating Templates—Admin Only
You can update Show templates to reflect the current System Settings by tapping UPDATE. You will then be asked to
confirm or cancel the update.
CALREC
Putting Sound in the Picture
67