Routing A Signal - Calrec SUMMA User Manual

ROUTING A SIGNAL

Routing a signal in Summa is quick and simple:
1. Access the path you wish to route, either using the ACCESS buttons situated above faders, or from the touch display
within the 'Buses & Outputs' window.
2. Next, tap to select the routing tab for the bus or output that you wish to route the path to and the relevant controls are
displayed within the control window.
3. If you are routing to a bus, tap to slide the on/off switch for the individual bus that you wish to route to.
FIGURE 1 - BUS ROUTING SWITCHES
4. If you are routing to an output (direct or mix minus), tap either MONO or STEREO to create the desired output for
the accessed path.
FIGURE 2 - ASSIGNING AN OUTPUT
166 SUMMA
Networked Audio Production System
ROUTING