Meter Layout Presets - Calrec SUMMA User Manual

Figure 3. below shows a partially customised meter layout using the largest single Main, Group Aux and Track meter
slot usage. The options apart from Full Height can add Dynamics, Downmix, Loudness, Pre Tone & TB and PreDelay
metering to the basic meter source and type, these other options vary depending on source type. Note that for some
meters a number of Layouts are made available for instance Main 2 can show the same information in an 8, 6 or 10 slot
configuration for layout 1,2 or 3 depending on user preference. Once a meter layout has been completed the user can
simply 'Apply New Layout to Surface' which puts the Meter layout onto the TFT screens or can tap the Layout Presets
button to Create New Presets from the layout, Load Old Presets from memory or Backup and Restore Meter Presets for
use with this or other Summa consoles.
FIGURE 3 - METER LAYOUT SCREEN PARTIALLY CUSTOMISED.

Meter Layout Presets

Figure 4. below shows the Layout Presets pop-up for the custom meters. From here the user can go back to select,
create, rename or delete another Meter folder. Or can in this meter folder:- make a New preset from the Meter layout,
Update a selected preset with the Meter Layout, Edit the name of a preset, Delete presets or Load a preset into the Meter
Layout screen. Note this does not apply the meter layout to the surface until the 'Apply New Layout to Surface' button is
tapped. Two further functions are available:- Backup and Restore, these allow the Meter Layout presets to be backed up
to / restored from a backup location. Typically this is held in a directory on a USB flash drive which is selected from the
screen once the Backup or Restore buttons have been tapped. This allows the user to transfer customised meter layouts
to/from a storage medium for subsequent use with this or other Summa consoles as the meter presets are independent
from Shows and Memories storage.
FIGURE 4 - METER LAYOUT PRESETS
CALREC
Putting Sound in the Picture
115