Programmable Contour/Orientation Tolerance (Ctol, Otol, Atol) - Siemens SINUMERIK 828D Programming Manual

Path traversing behavior

8.8 Programmable contour/orientation tolerance (CTOL, OTOL, ATOL)

8.8 Programmable contour/orientation tolerance (CTOL, OTOL, ATOL)
Function
The
for the compressor functions (COMPON, COMPCURV, COMPCAD), the smoothing types
G642, G643, G645, OST, and the orientation ORISON using machine and setting data in the
NC program.
The programmed values are valid until they are reprogrammed or deleted by means of the
assignment of a negative value. They are also deleted at the end of a program, in the event
of a channel reset, a mode group reset, an NCK reset (warm restart), and POWER ON (cold
restart). On deletion of these values, the values from the machine and setting data are
restored.
Syntax
CTOL=<value>
OTOL=<value>
ATOL[<axis>]=<value>
Significance
CTOL
OTOL
490
, , and commands can be used to adapt the machining tolerances defined
CTOL OTOL ATOL
Command for programming the contour tolerance
is valid for:
CTOL
• All compressor functions
• All rounding types except G641 and G644
: The value for the contour tolerance is specified as a length.
<value>
Type:
Unit:
Command for programming the orientation tolerance
is valid for:
OTOL
• All compressor functions
• ORISON orientation smoothing
• All rounding types except G641, G644, OSD
: The value for the orientation tolerance is specified as an angle.
<value>
Type:
Unit:
REAL
inch/mm (dependent on the current dimensions setting)
REAL
degrees
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
Job planning