Siemens SINUMERIK 828D Programming Manual page 34

Flexible NC programming
1.1 Variables
Table 1- 1
Number
1) This G command is used to address the setting data.
General conditions
Initialization value: Global user variables (GUD)
● Only
● In addition to
● In the case of global user variables (GUD) with the
Initialization value: FRAME data type
It is not permitted to specify an initialization value for variables of the
Variables of the
Initialization value: CHAR data type
For variables of the
ASCII character can be programmed in quotation marks, e.g. "A".
34
Programmable setting data
Identifier
42000 $SC_THREAD_START_ANGLE
42010 $SC_THREAD_RAMP_DISP
42400 $SA_PUNCH_DWELLTIME
42800 $SA_SPIND_ASSIGN_TAB
43210 $SA_SPIND_MIN_VELO_G25
43220 $SA_SPIND_MAX_VELO_G26
43230 $SA_SPIND_MAX_VELO_LIMS
43300 $SA_ASSIGN_FEED_PER_REV_SOURCE
43420 $SA_WORKAREA_LIMIT_PLUS
43430 $SA_WORKAREA_LIMIT_MINUS
43510 $SA_FIXED_STOP_TORQUE
43520 $SA_FIXED_STOP_WINDOW
43700 $SA_OSCILL_REVERSE_POS1
43710 $SA_OSCILL_REVERSE_POS2
43720 $SA_OSCILL_DWELL_TIME1
43730 $SA_OSCILL_DWELL_TIME2
43740 $SA_OSCILL_VELO
43750 $SA_OSCILL_NUM_SPARK_CYCLES
43760 $SA_OSCILL_END_POS
43770 $SA_OSCILL_CTRL_MASK
43780 $SA_OSCILL_IS_ACTIVE
43790 $SA_OSCILL_START_POS
(POWER ON) can be defined as the initialization time for global user variables
INIPO
(GUD) with the range of validity.
NCK
(POWER ON),
INIPO
the initialization time for global user variables (GUD) with the
or (NewConfig) initialization time, for an NC reset, mode group reset and
INICF
NewConfig, the variables are only reinitialized in the channels in which the named events
were triggered.
data type are initialized implicitly and always with the default frame.
FRAME
data type, instead of the ASCII code (0...255), the corresponding
CHAR
(reset) or (NewConfig) can be defined as
INIRE INICF
range of validity and
CHAN
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
G command
1)
SF
/
DITS DITE
PDELAYON
SETMS
G25
G26
LIMS
FPRAON
G26
G25
FXST
FXSW
OSP1
OSP2
OST1
OST2
FA
OSNSC
OSE
OSCTRL
OS
OSB
range of validity.
CHAN
INIRE
data type.
FRAME
Job planning
(reset)