Siemens SINUMERIK 828D Programming Manual page 92

Flexible NC programming
1.11 Repeat program section (REPEAT, REPEATB, ENDLABEL, P)
3. Repeat section between two jump markers:
<start jump marker>: ...
...
<end jump marker>: ...
...
REPEAT <start jump marker> <end jump marker> P=<n>
...
Note
It is not possible to nest the
the
not reached before the
the
4. Repeat section between jump marker and ENDLABEL:
<jump marker>: ...
...
ENDLABEL: ...
...
REPEAT <jump marker> P=<n>
...
Note
It is not possible to nest the
parentheses. If the
not reached before the
REPEAT
92
appears before the
<start jump marker>
REPEAT
statement will be repeated.
REPEAT
<jump marker>
REPEAT
statement will be repeated.
statement with the two jump markers in parentheses. If
REPEAT
REPEAT
statement, the section between the
statement with the
REPEAT
appears before the
statement, the section between the
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
statement and the
<end jump marker>
<start jump marker>
and the
<jump marker>
statement and the
REPEAT
<jump marker>
is
and
in
ENDLABEL
is
ENDLABEL
and the
Job planning