Siemens SINUMERIK 828D Programming Manual page 503

Significance
CTABDEF( )
CTABEND
<following axis>
<leading axis>
<n>
<periodicity>
<memory location>
Note
Overwrite
A curve table is overwritten as soon as its number (
(exception: the curve table is in active in an axis coupling or locked with
warning is output when curve tables are overwritten.
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
Start of curve table definition
End of curve table definition
Axis whose motion is to be calculated using the curve table
Axis providing the master values for the calculation of the following
axis motion
Number (ID) of curve table
The number of a curve table is unique and independent of the
memory location. It is not possible for there to be tables with the
same number in the static and dynamic NC memory.
Table periodicity
0 Table is non-periodic (table is processed only once, even for
rotary axes)
1 Table is periodic with regard to the leading axis
2 Table is periodic with regard to leading axis and following axis
Specification of memory location (optional)
"SRAM" The curve table is created in the static NC memory.
"DRAM" The curve table is created in the dynamic NC memory.
Note:
If a value is not programmed for this parameter, the default memory
location set with
MD20905 $MC_CTAB_DEFAULT_MEMORY_TYPE is used.
9.2 Curve tables (CTAB)
) is used in another table definition
<n>
CTABLOCK
Axis couplings
). No
503