Path Segmentation For Single Axes - Siemens SINUMERIK 828D Programming Manual

12.2.2

Path segmentation for single axes

If single axes are defined as punching/nibbling axes in addition to path axes, then the
automatic path segmentation function can be activated for them.
Response of single axis to SPP
The programmed path segment length (
reason, the SPP value is ignored in blocks which contain a single axis motion and an SPP
value, but not a programmed path axis.
If both a single axis and a path axis are programmed in the block, then the single axis
responds according to the setting of the appropriate machine data.
1. Standard setting
Example:
N10 G1 SON X10 A0
N20 SPP=3 X25 A100
As a result of the programmed distance between strokes of 3 mm, five blocks are generated
for the total traversing distance of the X axis (path axis) of 15 mm.
The A axis thus rotates through 20° in every block.
1. Single axis without path segmentation
2. With/without path segmentation
● Circular interpolation: Path segmentation
● Linear interpolation: No path segmentation
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
The path traversed by the single axis is distributed evenly among the intermediate blocks
generated by .
SPP
The single axis traverses the total distance in the first of the generated blocks.
The response of the single axis depends on the interpolation of the path axes:
12.2 Automatic path segmentation
) basically refers to the path axes. For this
SPP
Punching and nibbling
657