Siemens SINUMERIK 828D Programming Manual page 361

TRANSMIT transformation types
The TRANSMIT machining operations have two parameterizable forms:
●
●
The extended transformation type 257 can be used, for example, to compensate clamping
compensations of a tool with real Y axis.
Syntax
TRANSMIT
TRAFOOF
Rotary axis
The rotary axis cannot be programmed because it is occupied by a geometry axis and
cannot thus be programmed directly as a channel axis.
Significance
TRANSMIT
TRANSMIT(n)
TRAFOOF
OFFN
Note
An active
is activated in the relevant channel (e.g.,
Job planning
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
in the standard case with (TRAFO_TYPE_n = 256)
TRANSMIT
with additional Y linear axis (TRAFO_TYPE_n = 257)
TRANSMIT
or
TRANSMIT(n)
: Activates the first declared TRANSMIT function. This function is also
designated as polar transformation.
: Activates the nth declared TRANSMIT function; n can be up to 2
(TRANSMIT(1) is the same as TRANSMIT).
: Deactivates an active transformation.
: Offset contour normal: Distance of the face machining from the
programmed reference contour.
transformation is likewise deactivated if one of the other transformations
TRANSMIT
6.8 Kinematic transformation
, ,
TRACYL TRAANG TRAORI
Transformations
).
361