Siemens SINUMERIK 828D Programming Manual page 696

User stock removal programs
15.2 Generate contour table (CONTPRON)
Further information
Permitted traversing commands, coordinate system
The following G commands can be used for the contour programming:
● G group 1:
In addition, the following are possible:
● Rounding and chamfer
● Circle programming using
The spline, polynomial and thread functions result in errors.
Changes to the coordinate system by activating a frame are not permissible between
CONTPRON
Replacing the geometry axes with
alarm.
Relief cut elements
The contour description for the individual relief cut elements can be performed either in a
subprogram or in individual blocks.
Stock removal independent of the programmed contour direction
The contour preparation with
contour table is available independent of the programmed direction.
696
, , ,
G0 G1 G2 G3
CIP
and . The same applies for a change between
EXECUTE
CONTPRON
and
CT
while preparing the contour table produces an
GEOAX
was expanded so that after it has been called, the
Programming Manual, 07/2010, 6FC5398-2BP40-0BA0
and or and
G70 G71 G700
Job planning
.
G710