Installing a front-panel assembly
To install a front-panel assembly, complete the following steps.
1. Press the front-panel assembly into the front of the system-board tray and make
2. Connect the front-panel assembly cables to the system board and power-supply
3. Connect the other cables to the system-board tray.
4. Install the expansion enclosure, if you removed one (see "Installing an
5. Install the system-board tray in the chassis (see "Installing the system-board
Removing an I/O enclosure configured with 2.5-inch hot-swap hard
disk drives
To remove an I/O enclosure that is configured with 2.5-inch hot-swap hard disk
drives, complete the following steps.
sure that it is secure.
paddle card and close the cable retention latches. Carefully route the cables as
you connect the cables.
Note: Make sure that all cables are properly routed and that the cables do not
protrude from inside the system-board tray.
expansion enclosure on a system-board tray" on page 132); otherwise, install
the system-board tray cover (see "Installing the system-board tray cover" on
page 125).
tray in a 2U chassis" on page 127 or "Installing the system-board tray in a 3U
chassis" on page 129).
Chapter 5. Removing and replacing server components
193