Table of Contents
Advertisement
6. Install the heat sink onto the microprocessor as described in "Installing a
Removing a PCIe riser-card assembly from the I/O enclosure
To remove a PCIe riser-card assembly from the I/O enclosure, complete the
following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the system-board tray is installed in a chassis, remove it (see "Removing the
3. Remove the I/O enclosure from the system-board tray (see "Removing an
4. Carefully set the I/O enclosure on a flat, static-protective surface.
5. Remove the PCIe adapter bay cover from the I/O enclosure and save it for
6. Remove the PCIe adapter, if one is installed, and save it for future use (see
7. Remove the four screws that secure the PCIe riser-card assembly to the I/O
8. Pull the PCIe riser-card assembly off the mounting studs and out of the I/O
9. If you are instructed to return the PCIe riser-card assembly, follow all packaging
Installing a PCIe riser-card assembly in the I/O enclosure
To install a PCIe riser-card assembly in the I/O enclosure, complete the following
steps.
Note: If the grease is correctly applied, approximately half of the grease will
remain in the syringe.
microprocessor and heat sink" on page 199.
Two-slot
riser card
I/O enclosure
on page 123.
system-board tray from a 2U chassis" on page 126).
expansion enclosure from a system-board tray" on page 131).
future use (see "Removing the PCIe adapter bay cover" on page 143).
"Removing an adapter from the I/O enclosure" on page 151).
enclosure and save them for future use.
enclosure.
instructions, and use any packaging materials for shipping that are supplied to
you.
Chapter 5. Removing and replacing server components
203
Advertisement
Table of Contents
