Installing The Operator Information Panel Assembly - IBM System x3610 Problem Determination And Service Manual

1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cord and
3. Remove the cover (see "Removing the cover" on page 46).
4. Disconnect the operator-information panel cables from the system board and
5. From inside the server, press the release-latch on the operator information
6. Pull the assembly away from the front of the server and lift it out of the server.
7. If you are instructed to return the operator information panel assembly, follow all

Installing the operator information panel assembly

To install the replacement operator information panel assembly, complete the
following steps.
1. From the inside of the server, insert the tab on the left end of the operator panel
62
IBM System x3610 Type 7942: Problem Determination and Service Guide
on page 43.
all external cables.
remove them from the clips that are on top of the DVD drive cage assembly.
panel assembly toward the left side of the server and rotate the assembly
toward the inside of the server.
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
assembly into the left side of the opening in the inside front of the server.