Removing the power cord
To remove the power cord, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the 2U chassis or 3U chassis is installed in an iDataPlex rack, remove the
3. Disconnect the power cord that you are working on from the PDU.
4. Use an M3 hex driver to remove the two screws from the rail, and set them
5. Pull the mounting plate and power cord toward the front of the rack cabinet.
6. Separate the power cord from the mounting plate; then, set the mounting plate
7. If you are instructed to return the power cord, follow all packaging instructions,
Mounting
plate
Mounting
post
on page 123.
chassis from the rack (see "Removing the 2U chassis from a Type 7825
iDataPlex rack" on page 186 or "Removing a 3U chassis from a Type 7825
iDataPlex rack" on page 190).
aside.
aside.
and use any packaging materials for shipping that are supplied to you.
Plug
mount
Power
cord mounting
bracket
M3
screws
Power
cord
Chapter 5. Removing and replacing server components
145