Table of Contents
Advertisement
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the system-board tray is operating, shut down the operating system; then,
3. If external cables are connected to the front of the system-board tray or
4. Press in the two release latches and pull the system-board tray and expansion
Installing the system-board tray in a 2U chassis
To install the system-board tray in a 2U chassis, complete the following steps.
1. Slide the system-board tray into the chassis until it stops and the release
2. Reconnect the cables to the front of the system-board tray or expansion
on page 123.
press the power-control button to turn off the system-board tray (see "Turning
off the system-board tray" on page 10 for more information).
expansion enclosure, if one is attached, note where they are connected; then,
remove them.
enclosure out of the chassis.
latches click into place.
enclosure.
Chapter 5. Removing and replacing server components
127
Advertisement
Table of Contents
