Removing the 2U chassis fan-assembly top cover
To remove the 2U chassis fan-assembly top cover, complete the following steps.
Top cover
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the chassis is installed in an iDataPlex rack, remove it (see "Removing the 2U
3. Press the two cover-release buttons and slide the cover toward the rear of the
4. If you are instructed to return the 2U chassis fan-assembly top cover, follow all
Installing the 2U chassis fan-assembly top cover
To install the 2U chassis fan-assembly top cover, complete the following steps.
Top cover
1. Make sure that no wires are protruding and might interfere with the cover.
Release buttons
on page 123.
chassis from a Type 7825 iDataPlex rack" on page 186).
chassis to remove it.
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Release buttons
Chapter 5. Removing and replacing server components
135