Installing the 3U chassis fan assembly
To install the 3U chassis fan assembly, complete the following steps.
1. Touch the static-protective package that contains the fan assembly to any
2. Orient the fan assembly over the opening in the chassis. Make sure that the
3. Route any cables through the fan assembly.
4. Lower the fan assembly into the chassis and press down on the tab above the
5. Install the retention bracket.
6. Install the storage-riser-card assembly and ServeRAID SAS controller (see
7. Install the top cover (see "Installing the 3U chassis top cover" on page 137).
8. Install the 3U chassis in the iDataPlex rack (see "Installing the 3U chassis top
Removing and installing an adapter
The following section describes how to remove and replace PCIe adapters.
150
System x iDataPlex dx360 M2: Problem Determination and Service Guide
unpainted metal surface on the outside of the chassis; then, remove the fan
assembly from the package.
power connector on the fan assembly aligns with the connector on the power
supply.
power connector and make sure that it is fully seated.
"Installing a storage-riser-card assembly, ServeRAID SAS controller, and battery
cable interposer card in a 3U chassis" on page 183).
cover" on page 137).